Loading ...
Loading ...
Loading ...
Optimum temperature and air quality
30
Touch the OK sensor to confirm your
selection
or
wait about 5 seconds after the last
touch of the sensor.
The temperature being set will flash in
the display.
When you touch the sensors, you will
see the following changes in the dis-
play:
– With the first touch: The last temper-
ature selected flashes.
– Each subsequent touch of the sen-
sor: The temperature changes in 1°C
increments.
– Keeping your finger on the sensor:
The temperature changes continu-
ously.
A tone will sound (if the keypad tone
is switched on) when the lowest or
highest possible temperature is
reached.
Approximately 5 seconds after a sensor
has last been touched, the current
temperature inside the appliance is
shown automatically.
When the temperature is altered, there
is a short delay until the temperature
selected is set.
The temperature display in the control
panel always shows the actual tem-
perature.
Temperature range
In both zones, it is possible to set the
temperature between 5°C and 20°C.
Temperature display
In normal operation, the temperature
display shows the actual temperature in
the zone.
If the temperature in one of the zones is
not within the range that the appliance
is able to display, dashes will light up in
the temperature display.
Depending on the ambient temperature
and the temperature setting, it can take
the appliance a few hours to reach the
temperature required and for this tem-
perature to then be shown as a con-
stant temperature in the display.
Loading ...
Loading ...
Loading ...