Loading ...
Loading ...
INSTALLATION Three-Wire Electrical Connection to
Receptacle
INSTRUCTIONS
Read the "Dryer Safety" section of this Owner's Manual
and completely read these Installation Instructions before
beginning installation.
IMPORTANT: Observe all governing codes and
ordinances.
• The dryer must not be installed where it can be
exposed to water and/or weather.
• Check code requirements. Some codes limit or do not
permit installation of clothes dryers in garages, closets,
mobile homes, or sleeping quarters. Contact your local
building inspector.
Tools needed for installation:
Adjustable wrench or Pliers
N-inch nut driver
Wire stripper
Duct tape
Phillips screwdriver
Flat-head screwdriver
Level
A three-wire or four-wire, single phase 120!240-volt,
60-Hz., AC-only, electrical supply is required on a
separate 30-ampere circuit, fused on both sides of the
line. A time-delay fuse or circuit breaker is recommended.
This dryer is manufactured with the 3-wire, flame-ground-
ing conductor connected to the NEUTRAL (center) of the
wiring harness of the terminal block. Do not have a fuse
in the neutral or grounding circuit.
Use a 4-conductor cord when the dryer is installed in a
mobile home or an area where local codes do not permit
grounding through the neutral.
Fire Hazard
Use a new UL approved 30 ampere power supply
cord.
Use a UL approved strain relief.
Disconnect power before making electrical
connections.
Connect neutral wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected
to green ground connector.
Connect remaining 2 supply wires to remaining 2
terminals (gold).
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electrical shock.
Local codes may permit the use of a U.L.-listed,
120/240-volt minimum, 30-ampere, dryer power supply
cord kit (pigtail). Power supply cord should be type SRD
or SRDT and be at least four feet long. The wires that
connect to the dryer must end with ring terminals or
spade terminals with upturned ends.
Spadeterminals ......... 1
with upturnedends
J
This blade connected Ring
NEUTRAL _ to this conductor terminals
/f,+ ............................ %
¾, U.L.-listed, + NEUTRAL
strainrelief (whiteorcenter)
• The power supply cord must have three, No.-10 copper
wires to match a three-wire receptacle of NEMA Type
10-30R.
Three-wire
receptacle(NEMA
Type10-30R)
• Do not use an extension cord with this dryer.
• Do not connect plug end of power supply cord into a
live receptacle before connecting power supply cord to
dryer terminal block.
3
Loading ...
Loading ...
Loading ...