Loading ...
Loading ...
Loading ...
General Assembly
CONNECTING & DISCONNECTING TO
GAS SOURCE
Familiarise yourself with the general information and
safety guidelines located at the front of this manual.
Check
1. Gas cylinder is filled. A sloshing sound will be
heard when shaken.
2. The burner control is in the ‘OFF’ position.
Connecting
1. Ensure valve is in OFF position.
2. Check for any damage to the cylinder
connection. NEVER attempt to use damaged
equipment.
3. When connecting the hose to the cylinder tighten
the nut to a positive stop by hand or spanner.
4. Open cylinder valve fully. If a leak can be heard
at either end of the hose turn cylinder off and
tighten joint. Wait 5 minutes before re-testing
and use a soapy water solution to check the
joint. If bubbles appear the connection will need
to be re-tightened.
Disconnecting
1. Ensure the burner control is in the ‘OFF’ position.
2. Ensure the gas cylinder is in the full OFF position.
3. Detach the hose from cylinder.
LIGHTING PROCEDURE
Burner Operation & Ignition System Check
1. With cylinder valve in ‘OFF’ position push and
turn the control knob anti-clockwise to HIGH.
Check for sparking to the burners.
2. If spark is not evident at the burner ignition
point, check for any loose leads at either the
electrode or the ignition pack.
3. Push and turn anti-clockwise to HIGH the
control knob.
4. The side burner cover must be open before
pushing and turning the control knob anti-
clockwise to HIGH.
5. If the burner fails to light after several attempts
turn off the gas supply and inspect for any
obstructions to the gas flow.
If re–ignition is necessary while the gas barbecue is
still hot, you must wait for a minimum of 5 minutes
before commencing to re–ignite (this allows
accumulated gas fumes to clear).
• IMPORTANT: Before connecting and
disconnecting barbecue to gas source, make
sure burner controls are in ‘OFF’ position.
• CAUTION: When the barbecue is not in use,
the gas must be turned off at the cylinder.
• Check that the seals between the appliance
and the gas cylinder are in place and in good
condition before connecting the gas cylinder.
• Do not use this appliance if it has damaged
or worn seals.
• NOTE: If for some reason, ignitor fails to
produce a spark at the electrode, BBQ can
be lit by a long BBQ match. With hood
open insert lighted match into match
lighting hole positioned on the right hand
side of the BBQ body (underneath side
shelf). Push and turn the far right control
knob to HIGH. Burner ignition can be
checked through this hole. Subsequent
burners will cross light.
• Check performance of burner prior to
installing BBQ plates.
• Do not smoke when attempting to
ignite BBQ.
• Never use volcanic rock, heat beads or
other material.
• Always use protective gloves when
handling hot components.
IMPORTANT
IMPORTANT
Loading ...
Loading ...
Loading ...