Loading ...
Loading ...
Loading ...
Problem and alarm code Possible cause and solution
The appliance trips the circuit-
beaker.
• The amperage is insufficient to supply simultaneously all the ap-
pliances in use. Check the socket amperage and the capacity
of the meter or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact an Authorised
Service Centre.
Once you have checked the appliance, deactivate
and activate the appliance. If the problem occurs
again, contact an Authorised Service Centre.
For alarm codes not described in the table, contact
an Authorised Service Centre.
WARNING! We do not recommend
using the appliance until the problem
has been completely fixed. Unplug the
appliance and do not plug it in again
until you are certain that it operates
correctly.
THE WASHING AND DRYING RESULTS ARE NOT SATISFACTORY
Problem Possible cause and solution
Poor washing results. • Refer to "Daily use", "Hints and tips" and the basket load-
ing leaflet.
• Use more intensive washing programme.
• Activate the Extra Power option to improve the washing re-
sults of a selected programme.
• Clean spray arm jets and filter. Refer to "Care and Clean-
ing".
Poor drying results. • Tableware was left for too long inside the closed appliance.
Activate AirDry to set the automatic opening of the door and
to improve the drying performance.
• There is no rinse aid or the dosage of rinse aid is not suffi-
cient. Fill the rinse aid dispenser or set the level of rinse aid
to a higher level.
• The quality of the rinse aid can be the cause.
• We recommend to use rinse aid always, even in combination
with multi-tablets.
• Plastic items may need to be towel dried.
• The programme does not have the drying phase. Refer to
"Programmes overview".
There are whitish streaks or blu-
ish layers on glasses and dishes.
• The released quantity of rinse aid is too high. Adjust the rinse
aid level to a lower level.
• The quantity of detergent is too high.
There are stains and dry water
drops on glasses and dishes.
• The released quantity of rinse aid is not sufficient. Adjust the
rinse aid level to a higher level.
• The quality of the rinse aid can be the cause.
The interior of the appliance is
wet.
• This is not a defect of the appliance. Humid air condensates
on the appliance walls.
20
Loading ...
Loading ...
Loading ...