Loading ...
Loading ...
Loading ...
BEFORE FIRST USE:
1. Before using your Bowl Lift Stand Mixer, remove all packing material, plastic,
labels, stickers or tags that may be attached to the Mixer, Bowls or Attachments.
2. Before the first use of the Stand Mixer, wash the white Flat Beater, white Dough
Hook, and Stainless Steel Bowls in warm, sudsy water or in the dishwasher. The
Wire Whip should be washed by hand only. Rinse and Dry all thoroughly.
3. The exterior of the Stand Mixer should only be cleaned with a soft damp cloth,
then dried.
4. Place Bowl Lift Stand Mixer on a dry, level, stable, surface such as a countertop
or table. Keep Mixer away from countertop edge. Be sure to leave plenty of
room around Air Vents at the rear of Mixer.
NOTE: Do not useabrasive cleansers or scouring pads when cmeaning
your Bowl Lift Stand Mixer, NEVERimmerse the body of the Stand Mixer
inwater or any liquid.
TO ATTACHBOWLS TO MIXER
1. Turn Speed Control Knob to OFE
2. Unplug Stand Mixer or disconnect power.
3. Place Bowl Lift Handle in down position (Fig. 2).
4. Fit the Bowl Supports over Locating Pins (Fig. 3).
NOTE: For both Bowls, fit the Detent Ball on the back of the Bowl into the Detent for it
on the Mixer. (Fig. 4).
5. Raise the Bowl Lift Handle up into the Locked postion (Fig. 5).
Fig. 5
CAUTION: Never turn on Mixer with Beater, etc. attached unless the
Bowl is in place. Failure to heed this advice could result in broken bones,
cuts or bruises.
Loading ...
Loading ...
Loading ...