Loading ...
Loading ...
Loading ...
8
Reversing the door
1. Stand the refrigerator, open the upper
door and remove the door shelves and close
it(preventing ). damage to the shelves
2. Use a putty knife or thin-blade
screwdriver to prize the screw hole cover
which is at the top left corner of the
refrigerator, and Unscrew the upper hinge
cover which is at the top right corner of the
refrigerator.
screw hole cover
screw
upper hinge
cover (right)
The side at which the door opens can be
changed from the right side (as supplied) to
the left side, if the installation site requires.
Tools you will need:
1. 8mm socket driver
2. cross-shaped screwdriver
Before you start
in order to gain access to the
base, you should rest it on soft foam
packaging or similar material to avoid
damaging the cooling pipes at the rear of the
refrigerator.
carefully tilt the refrigerator
backwards
3. Putty knife or thin-blade screwdriver
3.Unscrew the special flange self-tapping
screws which are used for fixing the right
upper hinge part by a 8mm socket driver or
a spanner(please support the upper door
with your hand when doing it ).
right upper hinge part
special flange
selftapping screws
4.Remove the upper hinge , transfer it to
reversed side and tighten securely, then put
it in a safe place.
pin
NOTE: When removing the door, watch for
washer(s) between the ceter hinge and the
bottom of the freezer door that may stick to
the door. Do not lose .
6.Unscrew the two special flange self-
tapping screws which are used for fixing the
middle hinge part, then remove the middle
hinge part that the lower door in place.
these
holds
5.Lift the upper door and set it on a non
scratching surface with the outside up
middle hinge part
special flange
selftapping screws
Loading ...
Loading ...
Loading ...