Loading ...
Loading ...
Loading ...
42
Before Calling For Service (cont.)
The display
shows “d90”,
“d95”
• The duct work is about 90%-
95% blocked.(“d90” or “d95” error
code displayed 2 hours only)
• House exhaust system blocked.
•
Using the dryer with a
severely restricted exhaust is dangerous and could result
in a fire or other property damage.
• Check the outside dryer vent while the dryer is operating
to make sure there is strong airflow.
• If the exhaust system is extremely long, have it repaired or
rerouted.
• Keep the area around the dryer clean and free of clutter.
• Check vent hood for damage or lint clogging.
• Make sure the area around the vent hood is clear.
Steam does not
generate but
no error code is
shown
• Water level error. • Unplug dryer and call for service.
Garments still
wrinkled after
STEAM FRESH™
• Too many or too different types
of garments in dryer.
• Small loads of 1 to 5 items work best.
• Load fewer garments. Load similar-type garments.
There are no
creases left on
garment after
STEAM FRESH™
• The function of this cycle is to
remove wrinkles from fabric.
• Use an iron to make creases.
Garments have
static after
REDUCE STATIC
• This is normal. • Depends on individual moisture level in skin.
Garments are
too damp or
too dry after
REDUCE STATIC
• Correct drying options not
selected.
• Select load weight manually before starting REDUCE
STATIC option.
Garments are
not uniformly
damp after
EASY IRON
•
Number of garments or load
size not properly selected at the
beginning of the cycle.
• Select the correct number or garments or load size before
starting the cycle.
Water drips
from door
during Steam
Cycle
• This is normal. • Condensation will normally form on the inside of the
dryer door during steam operation. Some condensation
may drip out the bottom of the door.
Steam is not
visible during
Steam Cycle
• This is normal. • Steam vapor is difficult to see when the door is closed.
However, condensation will normally form on the inside of
the dryer door if the steam system is operating normally.
Drum does not
turn during
Steam Cycle
• This is normal. • The drum is turned off so that the steam vapor remains in
the drum. The drum will normally turn for about 2 seconds
once a minute.
TROUBLESHOOTING
MFL67731008_en_160524.indd 42 2016.5.24 10:51:54 AM
Loading ...
Loading ...
Loading ...