Loading ...
Loading ...
Loading ...
7
SWITCHING ON
• Turn the temperature control dial to 'min' and set the steam control to no steam.
• Sit the iron on its heel.
• Plug the power cord into the wall power outlet, and switch it on.
• A red indicator light will illuminate.
• Turn the temperature control dial to bring the desired setting on the dial next to the
mark on the tank.
• When the iron reaches temperature, the power on/temperature ready indicator will turn off and
will then cycle ON and OFF as the thermostat operates to maintain temperature
AUTO SHUT-OFF
• If the iron is motionless, the element will switch off after 30 seconds if lying on its soleplate or on
its side and 8 minutes if it is sitting upright.
• The red light will blink continuously until you move the iron.
• To switch on again, lift up the iron, tilt it forward and then sit it upright.
• No settings are lost during auto shut-off
REDUCING TEMPERATURE
This can take time, as the iron has to lose the heat it has built up. It is best to organise your
ironing so that you do not need to reduce the temperature.
STEAM IRONING
When steam ironing, you must set the temperature control dial above the wool setting, to ensure
the iron is in the steam temperature range. Make sure the water tank is full.
• Move the steam control to the setting you want and commence ironing.
• The steam control is variable. Choose a position between the no steam and high steam
that best suits your steam requirements.
NOTE: When steam ironing at the lower end of the steam temperature range, it is preferable to set the
steam control to a low steam setting, in order to reduce the incidence of water droplets.
COOL SPRAY MIST
NOTE: Water spotting affects some fabrics. Test this out on a hidden part of the fabric first. The cool spray
mist works with dry or steam ironing, as long as there is water in the tank.
• Check that there is water in the tank.
• Lift the iron off the fabric.
• Aim the cool spray mist nozzle at the fabric.
• Press the cool spray mist trigger – you may have to press it 2 or 3 times to pump water
through the system.
Loading ...
Loading ...
Loading ...