Loading ...
Loading ...
Loading ...
6
INSTALLING THE WATER FILTER HOLDER AND CARBON FILTER
Thesuppliedlterreducesmanyofthecontaminantsthat
cannegativelyaffecttheavorofthecoffee.Although
the Coffee Maker will function normally without it, use of
thelterishighlyrecommended.
1ThelterassemblyconsistsofaWaterFilterHolder,
andanactivecarbonltercartridge.Priortoinserting
thecartridgeintotheholder,placethecarbonlter
cartridge into a container of clean cool water, and let
soak. After 10 minutes, remove the cartridge from the
container and thoroughly rinse under running tap water
for 10 to 15 seconds. This will remove any carbon
dustparticlesthatcouldmaketheirwayintoyourrst
brew.Thisstepisonlynecessaryfornewcarbonlters.
Repeatthisprocedureeachtimeyoureplacethelter.
Itisrecommendedthatthecarbonlterbereplaced
after each 60 brew cycles. A reminder on the LCD panel
will alert you once you have reached the 60th brew
cycle. To clear the reminder, simply press and hold the
Set button until the alert disappears.
2Toinstallthelter,placethecarboncartridgeintothe
Water Filter Holder cage, and snap the cage closed,
locking the cartridge into the holder.
3LowertheWaterFilterHolder,lterendrst,downinto
the bottom of the water reservoir and insert the holder
into the pocket located at the bottom of the reservoir.
4 Plug the Coffee Maker into a grounded outlet. You
should hear a short alert tone. Fill the reservoir with
clean, cool water. Do not exceed 12 cups of water, as
theoverowslotsinthebackofthereservoirwillcause
the excess water to run out the back of the unit and on
to the counter top.
If you are using a container other than the carafe to
llthereservoir,usethewaterlevelindicatorwindow
on the right side of the Coffee Maker to measure the
desired amount of water.
5 Place the Filter Basket into position and lower the
PermanentGold-Tonelterintothebasket-Donot
add coffee at this time! Place the empty carafe onto
the warming plate and press the On-Off button once
to start the brewing process. Allow the Coffee Maker
tocyclewithwater-onlyfortherstuse.Theunitwill
sound three alert tones once the brewing process has
completed. Discard the water from the break-in cycle.
NOTE
Repeat these steps each time you replace the carbon
lterelement.
Loading ...
Loading ...
Loading ...