Loading ...
Loading ...
Loading ...
29
Care and Cleaning
Removing and Replacing the Oven Door:
The door is heavy. For safe, temporary storage,
lay the door flat with the inside of the door facing down.
To remove the oven door
1. Open oven door completely, horizontal with floor (See
Figure 6).
2. Pull the door hinge locks on both left and right door hinges
down from the oven frame completely towards the oven
door (See Figure 7). A tool such as a small flat-blade screw-
driver may be required.
3. Firmly grasp both sides of oven door along the door sides.
Do not use the oven door handle (See Figure 8).
4. Close the door to approximately 10 degrees from the door
frame (See Figure 8).
5. Lift the oven door hinge arms over the roller pins located on
each side of the oven frame (See Figure 9).
To replace the oven door:
1. Firmly grasp both sides of oven door along the door sides.
Do not use the oven door handle (See Figure 8).
2. Holding the oven door at the same angle as the removal
position, seat the hook of the hinge arm over the roller pins
located on each side of the oven door frame (See Figure 8
and Figure 9). The hook of the hinge arms must be fully
seated onto the roller pins.
3. Fully open the oven door, horizontal with floor (See
Figure 6).
4. Push the door hinge locks up towards and into the oven
frame on both left and right oven door hinges to the locked
position (See Figure 7).
5. Close the oven door.
Important note: Special door care instructions - Most oven doors
contain glass that can break. Do not hit the glass with pots,
pans, or any other object. Scratching, hitting, jarring, or stressing
the glass may weaken its structure, causing an increased risk of
breakage at a later time. Do not close the oven door until all of
the oven racks are fully in place.
Figure 6: Door hinge location
Figure 7: Door hinge locks
Figure 8: Holding door for removal
Figure 9: Replacement and location of hinge arm and roller pin
Oven door
hinge
locations
L
O
C
K
about
10°
hinge
oven
door
roller
pin
hinge
arm
Loading ...
Loading ...
Loading ...