Loading ...
Loading ...
Loading ...
14
EN
Checking the Rubber Seal on the
Water Inlet Hose
Two rubber seals a are supplied with the water
inlet hoses. They are used for preventing water
leaks. Ensure the washers are in place before
connecting the inlet hose. Make sure the
connection to taps is sufficiently tight. Do not use
any mechanical device to overtighten the inlet
hoses. Hand tighten only with the aid of a soft cloth
if necessary. After both ends have been connected,
open the taps slowly and check for leaks. The
curved end of the inlet hose must be connected to
the machine.
Connecting the Hose to Water Tap
(Each country’s methods of
connection will vary. Refer to the
appropriate type below)
Connecting Screw-Type Hose to a Tap with a
Thread
Screw the hose connection to a water supply tap,
which has a ¾” threaded union. Use the straight
end of the hose to connect to the tap. Connect the
curved end of the hose to the machine.
NOTE
• Before connecting the inlet hose to the water
tap, turn on the water tap to flush out foreign
substances (dirt, sand, sawdust, and etc.) in the
water lines. Let the water drain into a bucket,
and check the water temperature.
Connecting the Hose to the
Appliance
Screw the water line to the water supply on the
back of the appliance.
NOTE
• After completing connection, if water leaks from
the hose, repeat the same steps. Use the most
conventional type of tap for the water supply. If
the tap is square or too big, remove the guide
plate before inserting the tap into the adaptor.
• Make sure that the hose should not be kinked
or trapped.
Connecting Screw-Type Hose to Tap
Without Thread
1
Loose the four fixing screws.
Fixing screw
Upper
connector
Rubber
seal
Loading ...
Loading ...
Loading ...