2. Product Appearance
4. Other Requirements
Communication Method: RF433 (FSK)
Low Power Consumption Requirement: Refer to the previous
remote control
PG-F02 Remote Control Specification
1. Product Overview
his software is the embedded software for the equipment cascade control
remote. It is used in conjunction with various cascade alarms to enable testing
, silencing, alarm source localization, and cascade setting functions for the
cascade alarms
TEST
Test Button:Triggers all devices to execute a test
simultaneously (Sound + Light + LCD Display)
MUTE
Mute Button:Synchronously mutes the alarm
sound of all devices (10 minutes of silence)
LOCATE
Alarm Source Localization ButtonDuring an alarm,
only the sound and light of the source device are
retained, while other devices remain silent
Pair
PairingAdd the remote control to the cascade
group
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected. -Consult the dealer or an experienced radio/TV technician for help.
* RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction.
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two
conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference
that may cause undesired operation.
§ 15.21 Information to user.
Any Changes or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
