70mm
70mm
To ensure MagSafe comaptibility, your phone must be an iPhone 12 series or newer
iPhone version. Use a magnetic case or without case. Non-magnetic case will block
magnetic connection and preventing the phone from attached to the MagSafe pad.
Note: To reach 25W, please use a certified PD charger adapter rated 30W or higher.
Safety Instructions:
WARNING: Failure to follow these instructions could result in fire, electric shock, injury, or
damage to the user,product,or other property.
1. Connect the power supply of the wireless charger into a power outlet that is close by and easy to
disconnect from the source.
2. Use indoors and in a dry location only; avoid charging near sources of heat and humidity.
3. Keep the wireless charger and power supply away from any liquids or moisture.
4. Unplug the wireless charger when not in use for long periods of time.
5. Do not store your device in very hot or very cold locations. lt is recommended to use your device
at room temperature.
6. Do not use if visible defects are observed on the wireless charger or power supply.
7. Do not attempt to service, modify, or disassemble the wireless charger or power supply.
8. Ensure proper alignment of devices on the charging areas to avoid overheating and inefficiencies.
25W Magnetic Charger
Magsafe Compatibility:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance between 20cm the radiator your body.
FCC Warning:
This device in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
All essential radio test suites have been carried out. This device will be applied to all Member States of
European Union.
This device was tested for uncontrolled environment operations. To comply with RF exposure requirements,
a minimum separation distance of 20cm must be maintained between the user’s body and the product.
EU:
Hereby, Shenzhen Yifeng Intelligent Technology Co., Ltd. declares that the product type M47 is in compliance
with Directives 2014/53/EU & 2011/65/EU. The full text of the EU declaration of conformity is available at the
following internet address: https://www.YFZN.cn/
Declaration of Conformity:
Radiated H-Field: -14.94 dBuA/m(@10m) (for EU only)
TX/RX Frequency Range: 110-148 KHz
Radiated H-Field: -13.11 dBuA/m(@10m) (for EU only)
TX/RX Frequency Range: 360 KHz
WPT:
Product Parameters:
Compatibility: Compatible with all wireless charging enabled phone and earbuds, including
iPhone 12-17 series, Google Pixel 10 series, and Samsung Galaxy S26-S20/Note/Z Fold/Z Flip
series (magnetic case is MUST required).
AirPods and other earbuds Output: 5W (requires magnetic charging case)
Full 25W support: iPhone 16 series, iPhone Air, iPhone 17 series, Galaxy S26 Ultra and
other devices that support 25W magnetic wireless charging
Note: Older models (iPhone 12-15 and iPhone 17e) are limited to 15W max
Model: M47
Input: 9-18V 2A
Phone Output: 25W(Max)
Earbud Output: 5W
Made in China
