Fan Accessories
1. Ensure the clamp is securely fastened to a stable,
load-bearing fixture. Tighten both knobs completely
to prevent detachment.
2. Verify that the fixture can support the fan’s weight before
attaching. Do not use on unstable or fragile surfaces.
3. Handle with care. Avoid dropping or exposing the clamp to
impacts that could weaken its integrity.
4. Inspect the clamp before each use for signs of wear, cracks,
or damage. Replace immediately if deterioration is detected.
5. Keep dry to prevent slippage and ensure a secure hold.
6. Keep out of reach of children.
7. Designed exclusively for FA05X Series. Do not force-fit or
modify to accommodate other products.
8. Keep fingers and hands away from the clamping mechanism
during use to prevent injury.
9. Avoid using excessive force on the fixture.
Note:
• Center the surface in the clamp before tightening to avoid
accidental damage. Fits surfaces up to 1.5” thick.
• Depending on the angle of the fan in the clamp, the misting
feature may stop. If you wish to continue misting, change the
angle of the fan head on the clamp so that it sits upright.
Please make sure to read the Shark™ Owner’s Guide prior to using your fan.
US: 1-855-523-4061 | sharkclean.com CA: 1-855-520-7816 | sharkclean.ca
FA05XCLAMP_QSG_E-F_REV_Mv2
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USE
Clamp Attachment
FA05XCLAMP
Fan Accessories
Clamp Attachment
FA05XCLAMP
1. Turn the large knob
counterclockwise
to loosen the vise.
Place the clamp
attachment on
a stable fixture,
ensuring the bracket
sits over it. Tighten
by turning the large
knob clockwise.
2. Remove the fan
head from its base
and slide the fan
head post into the
clamp. Support the
fan until the clamp is
tightened.
3. Turn the small knob
counterclockwise
to loosen the ball
joint. Adjust the fan
head to the desired
position, then
tighten the ball joint
by turning the small
knob clockwise.
Please make sure to read the Shark™ Owner’s Guide prior to using your fan.
US: 1-855-523-4061 | sharkclean.com CA: 1-855-520-7816 | sharkclean.ca
READ AND SAVE THESE INSTRUCTIONS.
INSTRUCTIONS FOR USE:
1. 3.
Tips for Usage
Note: When clamping to a vertical pole,
ensure the ball joint notch faces up. This
keeps the fan upright, ensuring optimal
misting performance.
Vertical Surfaces Horizontal Surfaces
