SPEED+
INCLINE+
INCLINE-
SPEED-
CAN ICES(B) / NMB(B)
PMN : 8844360
HVIN: 8844360
IC: 23730-CAREMOTE
Canada
operation.
(2)This device must accept any interference received, including interference that may cause undesired
(1)This device may not cause harmful interference, and
This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions :
FCC ID : 2A8UO-THEUSREMOTE
USA
incline- button on the treadmill once.
can be used to lower the incline. The decrement is the same as pressing the
INCLINE- Incline Decrease Button: When the treadmill is running, this buttonE.
incline+ button on the treadmill once.
can be used to raise the incline. The increment is the same as pressing the
INCLINE+ Incline Increase Button: When the treadmill is running, this buttonD.
pairing.
speed- button on the treadmill once. Press this button simultaneously during
can be used to decrease the speed. The decrement is the same as pressing the
SPEED- Speed Decrease Button: When the treadmill is running, this buttonC.
pairing.
speed+ button on the treadmill once. Press this button simultaneously during
can be used to increase the speed. The increment is the same as pressing the
SPEED+ Speed Increase Button: When the treadmill is running, this buttonB.
successful pairing.
ST/SP Start/Stop Button: Controls the start and stop of the treadmill afterA.
keep pressing «+» + «-». If succeed, Consolewill beep x3
Pairing: Remonte Control Close to Console (Seepicture),
Working Temperature: -10°C~ 40°C
Frequency: 2402 MHz ~ 2480 MHz
Product Name: Magnetic Remote Control W/ inclWorking
1. Please note that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
2. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
3. This equipment complies with radio frequency exposure limits set forth by the FCC for an uncontrolled environment.
4. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-
exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1)L’appareil ne doit pas produire de brouillage;
(2)L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
5. This equipment complies with radio frequency exposure limits set forth by the Innovation, Science and Economic Development Canada for an
uncontrolled environment.
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
Cet équipement est conforme aux limites d'exposition aux radiofréquences définies par la Innovation, Sciences et Développement économique Canada
pour un environnement non contrôlé.
Ce dispositif ne doit pas être utilisé à proximité d’une autre antenne ou d’un autre émetteur.
