FLAT 3C
Smart Phone
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: 1) this device may not cause harmful interference, and 2) this device
must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
ISED Statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions::
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation
of the device.
Cet appareil est conforme aux RSS sans licence d’Industrie Canada. L’exploitation
est soumise aux deux conditions suivantes :
(1) Ce dispositif ne peut causer d'interférences ; et
(2) Ce dispositif doit accepter toute interférence , y compris les interférences qui
peuvent causer un mauvais fonctionnement de l'appareil.
RF Exposure Statement
SAR tests are conducted using standard operating positions according standards with
the device transmitting at its highest certified power level in all tested frequency bands,
although the SAR is determined at the highest certified power level, the actual SAR
level of the device while operating can be well below the maximum value.
This model product has been tested and meets the RF exposure guidelines with the
test distance 0mm for head and 5mm for body worn. The highest SAR
1g
value is
0.706 W/Kg for head and 0.641W/Kg for body worn. The use of belt clips, holsters
and similar accessories should not contain metallic components in its assembly. The
use of accessories that do not satisfy these req
uirements may not comply with RF
exposure requirements, and should be avoided
Les tests DAS sont effectués dans des positions d'utilisation standard, conformément
aux normes, l'appareil émettant à sa puissance maximale certifiée dans toutes les
bandes de fréquences testées. Bien que le DAS soit déterminé à la puissance
maximale certifiée, le niveau DAS réel de l'appareil en fonctionnement peut être
nettement inférieur à cette valeur maximale.
Ce modèle a été testé et est conforme aux directives d'exposition aux
radiofréquences (RF) avec une distance de test de 0 mm pour la tête et de 5 mm
pour le port sur le corps. La valeur DAS maximale (1 g) est de 0,706 W/kg pour la
tête et de 0,64 1W/kg pour le port sur le corps. Les attaches de ceinture, étuis et
accessoires similaires ne doivent pas contenir de composants métalliques.
L'utilisation d'accessoires non conformes à ces exigences peut entraîner une non-
conformité aux exigences d'exposition aux RF et devrait être évitée.
