2.4G LED LIGHT REMOTE CONTROLLER
User Manual
1. Introduction
This 2.4G RF remote controller is designed for use with compatible dimmable
and color-temperature-adjustable LED lighting products. It provides wireless,
precise control over light on/off, brightness, and color temperature, with multip
le preset modes for different scenes.
2. Pairing Instructions (2.4G RF)
This remote uses 2.4G RF technology for stable, wall-penetrating control. To p
air with your light:
Power on the light within pairing range.
Within 3 seconds of powering on, press and hold the ON button (or follow the
pairing steps of your specific light).
The light will blink once to confirm successful pairing.
The remote is now ready for use.
Note: Multiple lights can be paired to one remote, or multiple remotes can con
trol one light.
3. Operation Guide
Power Control: Press ON to turn the light on; press OFF to turn it off.
Adjust Brightness: Use the sun icon buttons to increase/decrease brightness,
or select a preset level (100%, 80%, 60%, 40%, 20%).
Adjust Color Temperature: Use the COOL/WARM buttons on the dial, or selec
t a preset color mode (Cool, Bright, Neutral, Soft, Warm).
Night Light Mode: Press the crescent moon button to activate the low-brightne
ss night light setting.
4. Specifications
Frequency: 2.4GHz RF
Control Distance: Up to 30 meters (open area)
Battery: 2 x AAA batteries (not included)
Operating Temperature: 0°C ~ 40°C
Compatible Lights: 12-24V DC LED lights with 2.4G receiver
5.Safety and Maintenance
Do not expose the remote to high temperatures, direct sunlight, or water.
Remove batteries if the remote will not be used for a long time to prevent leak
age.
Clean the remote with a soft, dry cloth; do not use alcohol or chemical cleaner
s.
Keep the remote away from strong electromagnetic interference sources (e.g.,
microwave ovens, routers).
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interferenceto radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure
condition without restriction.
