VDI3N001 User Manual
Hardware and Installation
1. Locate the Diagnostic port on your vehicle. If the Vehicle uses J1939 use the optional 9
to 16 pin adapter
2. Plug in the device into the port – LED should light up indicating device is powered up
3. Turn on vehicle ignition
4. A Blue or Green blinking LED will indicate that the device is powered up and
communicating with the vehicle
Regulatory Information
FCC: This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Modications not expressly approved by Netradyne could void the user’s authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
o and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement: This equipment complies with FCC/IC radiation exposure limits
set forth for an uncontrolled environment in accordance with FCC rule part §2.1093 and KDB
447498 D01. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
ISED: This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
Cet appareil contient des émetteurs/récepteurs exempts de licence qui sont conformes aux RSS
exemptés de licence d'Innovation, Sciences et Développement économique Canada.
L'exploitation est soumise aux deux conditions suivantes :
1. Cet appareil ne doit pas provoquer d'interférences.
2. Cet appareil doit accepter toute interférence, y compris les interférences susceptibles
de provoquer un fonctionnement indésirable de l'appareil.
Déclaration relative à l'exposition aux rayonnements : Cet équipement est conforme aux limites
d'exposition aux rayonnements de la FCC/IC établies pour un environnement non contrôlé,
conformément à la section §2.1093 des règles de la FCC et au document KDB 447498 D01. Cet
équipement doit être installé et utilisé en respectant une distance minimale de 20 cm entre
l'émetteur et votre corps.
