03
02
Charging and Active
Charging the device to active before the first time using; To charge your device,
plug the charging cable into the adapter or USB port on your computer.
Pairing
The MAC address on the “Setting”-”About” page could help you identify your
device on the scanning list.
Charging contacts
Magnetic charging cable
USB plug
Downloading the App
Please follow the steps below to obtain the QR code and download the app.
Power on
Set up
Pull down to enter the
control center page
Scroll to the bottom
Click "About"
Click "APP Download" Downloading the
App
EN/英语
Open the App and set up your profile
Go to the [Device] , Click Add a [Device]
Choose your device on the scanning list
Finish
General Info & Specifications
Operating temperature: 14°F to 122°F (-10°C to 50°C)
Non-operating temperature: -4°F to 140°F (-20°C to 60°C)
1. Environmental Conditions
3. Disposal and Recycling
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B diaital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation, This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmfulinterference to radio communications,
However, there is no quarantee that interference will not occur in a particular installation, if
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: -Reorient or relocate the receiving
antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit diferent from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure reguirement. The devicecan
be used in portable exposure condition without restriction.
Please kindly be aware that it is the consumer’s responsibility to properly dispose and recycle
Smart Bracelet and accompanying components. Do not dispose of Smart Bracelet with common
household waste, the Smart Bracelet unit is considered electronic waste and should be disposed
Warning:
If the battery bulges, overheats, emits an unusual odor, or leaks, stop using the watch
immediately and disconnect the power.
Keep the watch strap clean and dry to avoid prolonged skin irritation from sweat and
dirt.
of at your local electronic equipment collection facility.
For more information, please contact your local electronic equipment waste management
authority or the retailer where you bought the product.
Fits a wrist between 5.5 and 7.7 inches in circumference.
2. Size
