Insert IC card, please insert IC card
chip Up and down the arrow shown
in the rightHead Direction Insertion
POS Machine
When swiping the card, please insert
the magnetic stripe card into the slot.
Swipe smoothly from left to right
Please hold the card face
horizontally.Close to equipment
according to map position
9、Power button
7、Contactless card reader
6、IC card slot reader
5、Display screen
3、Magnetic stripe
card slot
2、Top camera
10、Printer
14、Wrist strap
12、SIM、PSAM Card
slot (Internal)
11、 Speaker
AF��� Instructions
8、USB charging interface
4、Custom button
1、Black and white
display screen
13、Battery
FCC Warning：
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
SAR tests are conducted using standard operating positions accepted by the FCC with
the device transmitting at its highest certified power level in all tested frequency bands,
although the SAR is determined at the highest certified power level, the actual SAR level
of the device while operating can be well below the maximum value. Before a new device
is a available for sale to the public, it must be tested and certified to the FCC that it does
not exceed the exposure limit established by the FCC, Tests for each device are
performed in positions and locations as required by the FCC.
For body worn operation, this device has been tested and meets the FCC RF exposure
guidelines when used with an accessory designated for this product or when used with an
accessory that contains no metal and that positions the device a minimum of 10 mm
from the body.For limb worn operation, this device has been tested and meets the FCC
RF exposure guidelines. Non-compliance with the above restrictions may result in
violation of RF exposure guidelines
