BELL+HOWELL
®
STRING LIGHTS RETRACTABLE 50FT ITEM NO. 6914ENLQPH
DISTRIBUTED BY EMSON
®
NEW YORK, NY 10001, USA ©2025 EMSON
®
ALL RIGHTS RESERVED. MADE IN CHINA.
This product uses a Lithium battery. When it can no longer be used, it should be removed
from the unit and
recycled. The battery must not be incinerated or composted. The battery
can be taken for disposal to any local retailer participating in the national recycling program
sponsored by the RBRC (SEE RBRC seal). Call your local details, or the RBRC hotline at
1-800-820-8837 for the closest recycling center to you.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
INSTRUCTIONS
USAGE
SETTING UP
1. Pull the rubber cover to expose the charging port.
See Diagram 1 on right.
2. Insert the USB-C end of the provided charging
cable into the flashlight and the other end into any
USB power source (USB adapter, power bank, etc.)
3. The battery indicator light will light up red
while charging.
4. It will take approximately 2-3 hours to fully charge
your unit.
5. Once the unit is fully charged, the charging indicator
light will turn green.
1. Pull up the small hook located on the side of the unit
to unreel the string lights.
2. Secure the lights using the small hook. Display the lights
in any desired way.
3. Attach the main unit to any metal surface using the 3
magnets or use the reel/hook to hang it.
CHARGING STRING LIGHTS
WARNING! DO NOT SHINE DIRECTLY INTO EYES.
USB-C
Charging
Cable
DIAGRAM 1
INSERT
USB-C
CABLE
1. Lightly press the Power button
to turn the unit on (RGB ON).
2. Keep pressing the Power
button to go through the rest
of the String light/Spotlight
settings:
• RGB SLOW FLASH
• RGB FADING
• RGB FAST FLASH
• RGB + WARM WHITE ALTERNATING
• WARM WHITE ON
• WARM WHITE FADING
• SPOTLIGHT ON
• SPOTLIGHT ON + WARM WHITE ON
• SPOTLIGHT ON + RGB ON
• OFF
3. Press and hold the Power button for 3-5 seconds to turn the FLASHLIGHT on HIGH.
Lightly press the Power button to go through the rest of the Flashlight settings:
FLASHLIGHT LOW, FLASHLIGHT STROBE and OFF.
Battery:
Lithium rechargeable 18650 battery, 1800mAh
Light source:
36pcs SMD+125pcs LED + 1pc LED Flashlight
Lumens:
Flashlight-100lm; SMD-150lm
Color Temp
(Kelvin)
:
SMD 2835: 2900K
Flashlight: 12000K
WW string light: 2600K
Size:
D5.12x H3" (D13 x H7.6cm)
Weight:
0.97lbs (440g)
String Lights
: 50 feet (15.24m)
USB cable:
Type-C (20"/50cm)
SPECIFICATIONS
BUILT-IN HOOK
Lift up the reel to use it as
a hook for hanging the lights.
See Diagram 4 on right.
Lift up the reel from one side to the other.
Use it to wind the lights inside the unit.
Slowly turn the reel clockwise to wind up
the string lights.
See Diagram 5 on right.
DIAGRAM 3
Magnet
Magnet
Small
hook
String
lights
Flashlight
Power/Mode
button
MagnetCharging
port
Reel/
Hook
PULL
PULL
DIAGRAM 2
STORAGE
String lights can operate continuously while plugged into an outlet or any USB source.
Please refer to the Charging section of the manual on previous page to connect the
unit to a power source.
CAUTION: Arrange the cable away from traffic area and where it will not be
tripped over.
DIAGRAM 4
DIAGRAM 5
PLUG AND PLAY FEATURE
