REQUIRES 3 X 1.5V AA & 2 X 1.5V AAA BATTERIES (NOT INCLUDED)
• Shark Boat
• Locate and open the battery compartment cover under the Shark Boat.
• Insert 3 X 1.5V AA batteries with polarities matching battery
compartment markings.
• Close battery cover and secure screws.
• Reminder: sealing strip MUST be in place to prevent water leaking.
• Controller
• Locate and open the battery compartment cover behind the Controller.
• Insert 2 X 1.5V AAA batteries with polarities matching battery
compartment markings.
• Close battery cover and secure screws.
• Reminder: sealing strip MUST be in place to prevent water leaking.
PRESS TO MOVE
FORWARD
PRESS TO MOVE
BACKWARD
PRESS TO TURN
LEFT
PRESS TO TURN
RIGHT
• Batteries are to be inserted with the correct polarity and always follow the
product and battery manufacturer’s instruction.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same equivalent type as recommended are to be used.
• Do not use rechargeable batteries unless specified.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before
being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Always remove exhausted or dead batteries from the product.
• Remove batteries from product before storage.
• The supply terminals are not to be short-circuited.
• Batteries may explode or leak if misused.
• Batteries should be installed by an adult only.
• Batteries may present a choking hazard.
• Keep away from young children.
1.5V AAA
1.5V AAA
SEALING
STRIP
1.5V AA
1.5V AA
1.5V AA
SEALING STRIP
• Wipe clean, remove batteries and store when not in use.
• Always keep hands away from propellers.
• Check and drain excess water for best performance.
1. Unplug WATER STOPPER.
2. Drain water by gently shaking Shark Boat rear pointing down.
3. Plug the WATER STOPPER back in place.
PLUGGED UNPLUGGED
WATER STOPPER
AUTO POWER ON
• Automatically turns on when Shark
Boat hits the water
(WATER SENSORS touch water).
• NO power switch is required.
WATER SENSORS
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This device contains licence-exempt transmitter(s) receiver(s) that comply with
Innovation, Science and Economic Development Canada's licence-exempt
RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must ac eause iy leterference, including interference that may
cause undesired operation of the device.
CHOKING HAZARD—Small parts.
Not for children under 3 years.
WARNING:
• Shark Boat • Controller • User’s manual
CONTENTS:
REMOTE-CONTROL
Shark Water Toy - User’s Manual
091-11-2784
Distributed by Target Corporation
Minneapolis, MN 55403
Guest Services 1-800-440-0680
©2026 Target Brands, Inc.
BATTERY INSTRUCTIONS:
CARE INSTRUCTION:
TO PLAY:
BATTERY WARNING:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruct ions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Ages 3+
This equipment complies with FCC‘s RF radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
