INSTRUCTION MANUAL
SE9150 / SE9155
SE9180 / SE9185
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic safety precautions should always be followed, including the
following:
Read all instructions before using this sewing machine.
Keep the instructions at a suitable place close to the machine. Make sure to hand them over if the machine is
given to a third party.
DANGER –
TO REDUCE THE RISK OF ELECTRIC SHOCK:
A sewing machine should never be left unattended when plugged in. The electrical socket, to which the
machine is plugged in should be easily accessible. Always unplug this sewing machine from the electric outlet
immediately after using and before cleaning, removing covers, lubricating or when making any other user
servicing adjustments mentioned in the instruction manual.
WARNING –
TO REDUCE THE RISK OF BURNS, FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSON:
• This appliance is intended for use by adults. The appliance can be used with adult supervision by (i) children
aged from 8 to 12 years and (ii) persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given instruction concerning use of the appliance in a safe way
and understand the hazards involved. Cleaning and user maintenance shall not be made by children without
supervision. It is not allowed for anyone to play with the machine. Children up to 8 years are not allowed to
use the machine.
• Do not allow to be used as a toy. Close attention is necessary when this sewing machine is used by or near
children.
• Use this sewing machine only for its intended use as described in this manual. Use only attachments
recommended by the manufacturer as contained in this manual.
• Never operate this sewing machine if it has a damaged cord or plug, if it is not working properly, if it has
been dropped or damaged, or dropped into water. Return the sewing machine to the nearest authorized dealer
or service center for examination, repair, electrical or mechanical adjustment.
• Never operate the sewing machine with any air openings blocked. Keep ventilation openings of the sewing
machine and foot control free from the accumulation of lint, dust, and loose cloth.
• Keep ngers away from all moving parts. Special care is required around the sewing machine needle.
• Always use the proper needle plate. The wrong plate can cause the needle to break.
• Do not use bent needles.
• Do not pull or push fabric while stitching. It may deect the needle causing it to break.
• Wear safety glasses.
• Switch the sewing machine o (“0”) when making any adjustment in the needle area, such as threading
needle, changing needle, threading bobbin, or changing presser foot, etc.
• Never drop or insert any object into any opening.
• Do not use outdoors.
• Do not operate where aerosol (spray) products are being used or where oxygen is being administrated.
• To disconnect, turn all controls to the o (“0”) position, then remove plug from outlet.
• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
• The foot control is used to operate the machine. Never place other objects on the foot control.
• Do not use the machine if it is wet.
• If the LED lamp is damaged or broken, it must be replaced by the manufacturer or its service agent or a
similarly qualied person, in order to avoid a hazard.
• If the cord connected with the foot control is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualied person, in order to avoid a hazard.
• The noise level under normal operating conditions is less than 76dB(A).
• The machine must only be used with foot control of type 33911.00025 manufactured by Shang Gong Group
Co., Ltd. Jiangsu Household Sewing Machine Branch (China).
SAVE THESE INSTRUCTIONS
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
To satisfy radio frequency exposure requirements, a separation distance of 8” (20 cm) or more should be
maintained between this device and persons during device operation. To ensure compliance, operations at closer
than this distance is not recommended. The built-in antenna used for this transmitter must not be co-located in
conjunction with any other antenna or transmitter.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the authorized SINGER® retailer or an experienced radio/TV technician for help.
The included interface cable should be used in order to ensure compliance with the limits for a Class B digital
device.
Any changes or modications not expressly approved by the party responsible for compliance could void
the user’s authority to operate this equipment.
Federal Communication Commission Interference Statement
For the USA and Canada
Responsible party: Singer Sourcing Limited LLC
1714 Heil Quaker Boulevard, Suite 130, LaVergne, TN
37086
Product name: SINGER® SE9150 / SE9155 / SE9180 / SE9185
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the
device.
To satisfy FCC&IC RF exposure requirements, a separation distance of 20 cm or more should be maintained
between the antenna of this device and persons during device operation.
To ensure compliance, operations at closer than this distance is not recommended
CE Declaration of Conformity
VSM Group AB Soldattorpsgatan 3, SE-554 74 Jonkoping, Sweden declare that the product:
Household Sewing Machine SINGER® SE9150 / SE9155 / SE9180 / SE9185 complies fully with following EU
directives:
• 2014/35/EU Low Voltage Directive
• 2014/30/EU EMC Directive
• 2011/65/EU RoHS Directive
and that the relevant harmonized standards are applied as listed:
• EN 60335-1:2012, A13:2017, A1:2019, A2:2019, A14:2019, A15:2021
• EN 60335-2-28:2003, A1:2008, A11:2018
• EN 62233:2008
• EN 50014-1:2021
• EN 55014-2:2021
• EN 61000-3-2:2019, A1:2021
• EN 61000-3-3:2019, A1:2019
• EN 63000
• EN 301 489-17 V3.2.0
• EN 301 489-1 V3.2.3
• EN 300 328 V2.2.2
Jönköping, January 2023
Carsten Raunsgaard
Manager Regulatory Compliance
Maintenance – 61
Technical Specication
Household sewing machine
Sewing Speed
Maximum 800 ± 50 rpm
(using straight stitch with default stitch length)
Rated Voltage
240V/50Hz,230V/50Hz,220V/50Hz,12
7V/50Hz,120V/50Hz,125V/50Hz,100V
/50Hz
Presser Foot Rise Height
6-12mm
Protection Class
II (Europe)
Stitch Width
0–7mm
Stitch Length
0–5mm
Type of Light
LED light
Machine Dimensions
Length: ≈607mm
Width: ≈358mm
Height: ≈308mm
Net weight
Machine only: 9.5 kg
Embroidery unit: 2.3 kg
WiFi Module
Frequency: 2.4 band / 802.11 b/g/n
Transmitting power: +17 dBm Reciever sensi-
tivity: –97 dBm
Nominal Consumption
<100W
Foot Control Model
33911.00025
The technical specications and this user’s guide can be changed without prior notice.
Service
Have Your Sewing Machine Serviced Regularly by Your Local Authorized Retailer!
If you have followed this troubleshooting information and still have problems, contact your retailer. It may be helpful to bring the
fabric, thread and stabilizer you are using with you. If you have a stitch out that shows the problem, please bring that as well. A
sewing sample will often give better information than words and help your technician diagnose the problem.
Non-Original Parts and Accessories
The warranty does not cover any defect or damage caused by use of non-original accessories or parts.
We reserve the right to change the machine equipment and the assortment of accessories without prior
notice, or make modications to the performance or design. Such modications, however, will always be
to the benet of the user and the product.
INTELLECTUAL PROPERTY
SINGER, and the Cameo “S” Design, are exclusive trademarks of The Singer Company Limited S.à.r.l.
or its Aliates.
MYSEWNET is an exclusive trademark of KSIN Luxembourg II, S.a.r.l.
Please note that on disposal, this product must be safely recycled in ac-
cordance with relevant National legislation relating to electrical/electron-
ic products. Do not dispose of electrical appliances as unsorted muncipal
waste, use separate collection facilities. Contact your local government
for information regarding the collection systems available. When replac-
ing old appliances with new ones, the retailer may be legally obligated to
take back your old appliance for disposal free of charge.
If electrical appliances are disposed of in landlls or dumps, hazardous
substances can leak into the groundwater and get into the food chain,
damaging your health and well-being.
IMPORTER TO THE UK:
VSM UK
Ravensbank House, Ravensbank Drive
North Moons Moat, Redditch. B98 9NA, United Kingdom
MANUFACTURER
VSM Group AB, SVP WORLDWIDE
Soldattorpsgatan 3, SE-55474 Jönköping, SWEDEN
471091526A • English • ©2023 The Singer Company Limited S.à.r.l. or its Aliates. • All rights reserved.
