Whispair X3M12S5.IP Rangehood

User Manual - Page 16

For X3M12S5.IP. Also, The document are for others Whispair models: X5L09S5, X5S09S5, X5V09S5, X5R09S5, X5R09W5, X5M10S5, X5V12S5, X5N12S5 X5N15S5

PDF File Manual, 28 pages, Read Online | Download pdf file

X3M12S5.IP photo
Loading ...
Loading ...
Loading ...
PART 1: HOOD INSTALLATION GUIDE
Ceiling Mounted Cassette and Universal Hung Hood
Models included: X9C12S5, X9B12S5, X9B15S5 and X5C10S5
14
STEP 1:
Using a weighted string line (plumb line), determine the central position of
hood on the ceiling. Ensure the
hood is mounted as close to the centre of
the cooking surface as possible. Mark the position. Before making the cut
out, check for obstructions like electrical cables, etc.
NOTE:
The height of the underside of the hood body must be a minimum of
600mm above an electric cooktop, for a gas cooktop a minimum of 600mm
above the highest part of the highest burner. If you are installing a BBQ Alfresco
specific model above a BBQ it must be installed at a minimum 1200mm above
the BBQ cooking surface. The maximum recommended height for a
cassette unit is 1500mm above the cooktop. If the instructions of the hob
specify a greater distance than the minimum detailed, this shall be the minimum
height for installation.
Building codes that stipulate a minimum dimension may vary from state to state,
please check with your local council prior to installation.
STEP 2:
Place the two (2) supplied supporting metal beams (500mm long) with
pre-drilled xing holes perpendicular (90) to the roof trusses.
STEP 3:
Fit the four (4) supplied 10mm threaded rod through the holes provided on the
supporting metal beams and secure with nuts and washers provided. Ensure
the rod drop height is sufcient to attach the hood and nut xings but is not
excessive that is will impede the placement of the lters.
STEP 4:
Refer to Part 2: Motor Installation Guide.
STEP 5:
Attach the exi-ducting to the top of the hood unit and x into place with a pipe
clamp (provided).
WARNING
DIMENSIONS ARE ACCURATE AT THE TIME OF PRINTING, HAUS GROUP RESERVES THE RIGHT TO
CHANGE SPECIFICATIONS WITHOUT NOTICE. FOR BUILDING PURPOSES THE UNIT SHOULD BE
PROVIDED TO THE CABINET MAKER / BUILDER / KITCHEN DESIGNER FOR EXACT MEASUREMENTS.
Threaded Rod
Supporting Metal Beams
Loading ...
Loading ...
Loading ...