Before using your washing machine,please
read this manual carefully and keep it for
future reference.
The drawings in this manual are for
instruction only,they may vary from the
model you buy
This manual is also available online.
Inside you will find many helpful hints on how to use and maintain your
washing machine properly. Just a little preventative care on your part
can save you a great deal of time and money over the life of your
washing machine You'll find many answers to common problems in the
chart of troubleshooting tips.lf you review the chart of Troubleshooting
Tips first. you may not need to call for service.
Important Hints
07
08
12
19
21
23
Note: Our Company reserves the right to change the design of the product.
The product you purchase may have been improved, and may not be
exactly the same as that indicat-ed herein. However, the performance
and usage of the product remain the same.
595*560*850mm
595*625*850mm
8.5kg
7.5kg
1950W
P109FLW
P139FLB
P108FLW P138FLB
Important Hints
THIS MACHINE IS FOR HOUSEHOLD USE ONLY
Please refer to your actual product.
You may need to have the following tools in order to install your new washer:
please contact your place of purchase immediately.
safe for future use.
moves
movement
Do not use a power board or extension lead.
Any electrical components (plug, power cord etc.) must be replaced by a
certified agent or qualified service personnel.
When pulling out the plug, hold the plug tightly and then pull it out. Do not
pull the power cord forcibly.
Please read this recommendation carefully to avoid the risk of
damaging clothes.
Do not load clothes over the rated load capacity.
are
Do no fill liquid level over the MAX indicator.
The following illustration is an example of the washing machine control panel.
This illustration is for reference only. Actual control panel may slightly differ.
lit,
a large unbalance.
severe
1、If you want to take out the clothes when there is
extended power outage, make sure the water level in the
drum is below the safe level, the temperature is under
40 ℃, and the inner drum does not rotate.
2、Open the drain pump cover at the bottom right of the
front side.
3、If the water level in the drum is higher than the bottom
edge of the door, make sure the water temperature is
below 40 ℃, then remove the rubber pipe plug, and
lower the end of the pipe. Let the water flow out until the
water level in the drum is lower than the lower edge of the
door or no water is flowing out , then put the plug back in pipe,
and put the pipe back.（Please be careful with the hot water in
the drum to prevent burns）
4、Pull down on the rod lightly, when hearing a light sound then
open the door and take out or put in the clothes.
5、Replace drain pump cover.
6、This method can only be used in emergency.
rust
drum
severe
satisfactory
The machines buttons will not
respond to presses
batteries
been activated.
dispersed well.
the wash cycle
The washer fill time is too slow
Water drainage is too slow
Door lock issue
Electrical motor issue
Heater issue
Temperature sensor fault
Communication failure
Inverter failure
Fabric Care Label
23
P108FLW/P138FLB
P109FLW/P139FLB
24
8C104-001893 A.1
TCL Electronics Australia Pty Ltd.
ABN 83 111 032 896
Telephone: 1300 738 149
www.tcl.com/au
