366013 Instruction Manual

Loading ...

MAKING ADJUSTMENTS

ADJUSTING EXTENSION TAB

PARALLELISM

1. Using a precision measuring tool, measure the distance

from the inside face of the Blade to the edge of the Miter

Slot. See Figure 35.

2. Using the correct scale, slide the fence so that the indicator

reads the value that was recorded in Step 1 and lock the

Rails in place.

3. If the two values agree, there is no need for adjustment.

If the values are not the same, you will need to re-adjust

your front and rear extension tabs.

4. Using supplied 4mm Allen wrench in a counter-clockwise

motion, loosen both front and rear extension tabs. See

Figure 36.

5. Move the extension tabs (with the fence attached) so that

the inside face of the fence is ush with the edge of the

miter slot (that was measured in Step 1). See Figure 37.

6. Once the Fence is the correct distance from the blade and

ush with the miter slot edge from front to back, you may

use the 5/32 inch Allen Key to re-tighten the extension

tabs.

7. To check this procedure, with the fence on the extension

tabs, slide the fence to a couple of dierent distances from

the blade and check to ensure that the scale readings are

accurate.

Figure 35

Figure 36

Figure 37

Loading ...

Delta 366013 10 In. Portable Contractor Table Saw