Loading ...
Loading ...
C250M-H (03/21)
3
Installation
1. Position the pole mount adapter on the pole and attach it to the pole with the stainless steel straps provided.
Tighten the strap screws securely.
2. Attach your mount to the pole mount adapter with the provided nuts and washers and securely tighten.
3. If you are using the WM2000 wall mount and require an ST1 support strut for additional support, install an
SPA102 pole mount adapter. Measure 14 inches (36 cm) down from the bottom of the WM2000 and mark the
pole. Center the SPA102 on the pole at the mark and attach the SPA102 to the pole with the stainless steel straps
provided. Tighten the strap screws securely. Attach the support strut wall swivel to the SPA102 with the provided
nuts and washers and securely tighten. Attach the ST1 clamp swivel to the WM2000 with the stainless steel clamp
(supplied) and securely tighten.
Figure 1. Typical Pole Mount Adapter Installation
WARNING: Only mount one camera system per set of stainless steel straps Installation
Torque: 35-45 in.lbs.
Spec
ifications
Construction
Finish
Dimensions
PA100
PA101, PA101-AW, PA101-SW
PA102
SPA102
Weight
PA100
PA101, PA101-AW, PA101-SW
PA102
SPA102
Aluminum
Gray polyester powder coat
8.00” H x 3.00” W (20.32 x 7.62 cm)
5.00” H x 4.00” W (12.70 x 10.16 cm)
12.78” H x 7.00” W (32.45 x 17.78 cm)
6.50” H x 7.00” W (16.51 x 17.78 cm)
0.9 lb (0.4 kg)
0.9 lb (0.4 kg)
3.4 lb (1.5 kg)
1.8 lb (0.8 kg)
(Design and product specifications subject to change without notice.)
FLAT WASHER
LOCK WASHER
NUT
FLAT WASHER
LOCK WASHER
NUT
WM2000
WALL MOUNT
STAINLESS
STEEL CLAMP
CLAMP SWIVEL
SPA102 POLE
MOUNT ADAPTER
STAINLESS
STEEL STRAP
ST1
STAINLESS
STEEL STRAP
PA102 POLE
MOUNT ADAPTER
SUPPORT STRUT
Loading ...