Loading ...
Loading ...
Loading ...
EN
©2021 Hestan Commercial Corporation
17
INSTALLATION
(continued)
POWER REQUIREMENTSPOWER REQUIREMENTS
This appliance is designed to use a grounded receptacle, 120 VAC Single Phase, 60 Hz, with a
current rating as shown in the model number listing on page 5. When installed outdoors, it must
be plugged into a Ground Fault Circuit Interrupter (GFCI) protected circuit.
Have the installer show you where the electric circuit breaker is located so you know how to shut
off the power to this appliance.
The appliance is equipped with a flexible electrical supply cord with a three-prong grounding plug.
It is imperative that this plug be connected to a properly grounded three-prong receptacle. If the
receptacle is not the proper grounding type, contact an electrician. Do not remove the grounding
prong from this plug.
Power Requirement
Voltage 120 Volts, 60 Hz
Current 7.4 Amperes
Consumption 888 Watts
CHOOSING DRAWER LOCATIONCHOOSING DRAWER LOCATION
Carefully select the location where the warming drawer will be placed.
• It should be located for convenient use in the kitchen. When used outdoors, it is recommended
to apply sealant to the outside of the case where it meets your outdoor cabinet/island structure
to prevent water intrusion. There is also a gasket on the drawer face to prevent water intrusion
at the front of the drawer.
• Make sure that electrical power can be provided to the location selected. If possible, the
receptacle should be accessible after the drawer is installed, so that the drawer can be
unplugged and plugged in after installation. The cord is about 47” [120 cm] long.
PREPARATIONPREPARATION
1. See drawings on the following pages for clearance and cutout dimensions
2. The warming drawer support surface must be a minimum 3/4” [19 mm] thick plywood platform.
It must support 100 lbs. [45 kg]. If the unit is installed outdoors, the platform should be made
of pressure-treated or marine-grade plywood, or other materials resistant to moisture and
insect damage.
3. The platform must be solid, level and flush with the bottom of the cabinet cutout. Additional
interior structures (side walls, etc.) may be needed to support this platform.
4. The cabinet must be secure against tipping when the drawer is opened. If necessary, install
additional bracing at the rear of the cabinet to prevent the cabinet from tipping away from the
wall when the drawer is opened.
5. For best performance results make sure the platform is level before placing the warming
drawer. Use shims under the unit as needed to level it. There is no way to level the warming
drawer after it has been installed.
• If the installation is not level, the door may slide open or not seal tightly, allowing heat to
escape, or water to enter.
CAUTION
Use extreme caution when moving or installing the drawer. It is very
heavy.
NOTICE
• DO NOT LIFT THE WARMING DRAWER BY THE DRAWER HANDLE.
• Be very careful when moving or installing the warming drawer to avoid damage to the frame or
damage to the cabinets.
• If installing the warming drawer below another product, refer to that product’s literature for
any installation or clearance requirements.
Loading ...
Loading ...
Loading ...