Loading ...
Loading ...
Loading ...
26
1. Verify the anti-
siphon disc is in
place.
2. Form a “U”
shape on the
end of the drain
hose with the
hose pointed
toward the
drain. Place
the formed end
in a laundry tub or a standpipe and
secure the drain hose with the cable
tie (provided in the manual bag) to the
standpipe, inlet hose, laundry tub, etc.
so the hose does not pull out from the
force of the water.
1. Anti-Siphon Disc
1
Connecting the Drain
1
2
1. Insert less than 8.5” (21.5cm).
2. Cable tie
1. Plug the power cord into a grounded
outlet.
Completing the Installation
2. Turn on the power at a circuit breaker/
fuse box.
3. Carefully slide the washer to its final
position. Recheck for level and rock
corners for stability. See
Leveling the
laundry center.
Remove and discard
door tape.
4. Run the washer through a complete
cycle, checking for water leaks and
proper operation.
5. If you have any questions during
initial operation, please review the
Troubleshooting
section before calling
for service.
6. Place these instructions in a location
near the washer for future reference.
Connecting the Electrical
System
The following are specific requirements for
proper and safe electrical installation of
your laundry center. Failure to follow these
instructions can create electrical shock and/
or a fire hazard.
INSTALLATION
NOTE
The standpipe inside diameter must be
1-1/4” (3.2 cm) minimum. There must be
an air gap around the drain hose in the
standpipe. A snug hose fit can cause a
siphoning action.
NOTE
A wiring diagram and technical data
sheet are located behind the control
panel.
WARNING
ELECTRICAL SHOCK HAZARD
Improper connection of the equipment
grounding conductor can result in a risk
of electrical shock. Check with a licensed
electrician if you are in doubt as to whether
the appliance is properly grounded.
IMPORTANT
Check to ensure the power is off at a
circuit breaker/fuse box before plugging
the power cord into an outlet.
Loading ...
Loading ...
Loading ...