Loading ...
Loading ...
Loading ...
OPERATING INSTRUCTIONS
17
WATER DRAINAGE
Ensure the air conditioner is turned off and
unplugged and that it is close to a fl oor drain before
setting up any drain option.
1. Drain Plug
When the internal drain pan becomes full the
appliance will beep 8 times and the digital display
will show error code P1. The air conditioning or
dehumidifying action will stop but the fan may
continue to operate.
Remove the drain plug and allow the water to
completely drain. Replace the bottom drain plug,
pressing fi rmly to ensure a tight fi t and no leaks.
2. Continuous Drain
During dry mode, you may wish to install a
continuous drain option so that the air conditioner
will automatically drain collected water.
Remove the upper drain plug and attach the drain
hose that was provided with the air conditioner.
Place the open end of the drain hose over the
receptacle that it will drain into; this could be a
basement fl oor drain, a sink or similar.
Ensure that there are no kinks or bends in the drain
hose and that it goes straight down toward the fl oor.
The continuous drain is activated by gravity only.
If the hose is not positioned directly downwards,
water will not drain correctly.
AUTO RESTART
If the air conditioner loses power unexpectedly,
it will resume the previous settings once power is
restored.
When the air conditioner has been turned off, it
cannot be restarted for 3 minutes to protect the
internal components.
LOUVER ADJUSTMENT
When the air conditioner is turned on, the louver
opens fully.
Press the swing button to being the louver
movement. The louver will swing up and down
automatically. Press the swing button again to stop
the automatic louver swing.
Please do not adjust the louver manually.
WIRELESS CONNECTION
This air conditioner can be controlled with a
wireless application on your wireless device.
Visit https://www.danby.com/support/apps to
download the application and learn about its
operation.
SHORTCUT
Shortcut can be used to save a favourite setting. Set
the air conditioner to the desired temperature and
fan speed. Press and hold the shortcut button for 2
seconds. Press the shortcut button at any point in
future to return to the favourite setting. Shortcut is
only available on the remote control.
If no shortcut is set, pressing the shortcut button will
set the air conditioner to run in auto mode at 29°C
(79°F), with fan speed set to auto.
1
2
Loading ...
Loading ...
Loading ...