Loading ...
Loading ...
Loading ...
In the use of the product, you must be in strict
compliance with the electrical safety regulations of the
nation and region.
Input voltage should meet both the SELV (Safety Extra
Low Voltage) and the Limited Power Source with 12 VDC
according to the IEC60950-1 and IEC62368-1 standard.
Refer to technical specifications for detailed
information.
The socket-outlet shall be installed near the equipment
and shall be easily accessible.
An all-pole mains switch shall be incorporated in the
electrical installation of the building.
Do not connect multiple devices to one power adapter
to avoid over-heating or a fire hazard caused by
overload.
Make sure that the plug is firmly connected to the
power socket.
If smoke, odor or noise rise from the device, turn off the
power at once and unplug the power cord, and then
contact the service center.
Never attempt to disassemble the camera by
unprofessional personal.
Cautions
CAUTION: Hot parts! Burned fingers when handling the
parts. Wait one-half hour after switching off before
handling parts. This sticker is to indicate that
the marked item can be hot and should not
be touched without taking care. For device
with this sticker, this device is intended for installation
in a restricted access location, access can only be gained
by service persons or by users who have been
instructed about the reasons for the restrictions applied
to the location and about any precautions that shall be
taken.
The equipment shall not be exposed to dripping or
splashing and that no objects filled with liquids, such as
vases, shall be placed on the equipment.
Shock hazard! Disconnect all power sources before
maintenance.
No naked flame sources, such as lighted candles, should
be placed on the equipment.
Install the equipment according to the instructions in
this manual.
To prevent injury, this equipment must be securely
attached to the floor/wall in accordance with the
installation instructions.
Do not drop the camera or subject it to physical shock.
Do not touch senor modules with fingers.
Do not place the camera in extremely hot, cold (the
operating temperature shall be -40°C to 60°C), dusty or
damp locations, and do not expose it to high
electromagnetic radiation.
If cleaning is necessary, use clean cloth with a bit of
ethanol and wipe it gently.
Do not aim the camera at the sun or extra bright places.
The sensor may be burned out by a laser beam, so
when any laser equipment is in using, make sure that
the surface of sensor will not be exposed to the laser
beam.
Do not expose the device to high electromagnetic
radiation or extremely hot, cold, dusty or damp
environment.
To avoid heat accumulation, good ventilation is required
for the operating environment.
Keep the camera away from liquid while in use for non-
water-proof device.
Loading ...
Loading ...
Loading ...