Loading ...
Loading ...
Loading ...
Low and High Level Input Wiring
L+ R+
L- R-
Low-level (RCA) input wiring is preferred for best audio performance. Most trunk or hatchback installations will require a 15-20 foot RCA cable, while
pickup trucks and under-seat installations will require a 6-12 foot RCA cable. Always use a high-quality cable.
The high level input (s) should only be used when your receiver lacks RCA outputs. If the RCA outputs are not present, connect the speaker outputs
from the receiver to the high level input connector of the amplifier. Be sure to observe polarity to avoid audio phase problems. NOTE: Do not connect
BOTH the high level and low level inputs from your receiver to your amplifier at the same time!
NOTE: Do not connect BOTH the high level and low level inputs from your receiver to your amplifier at the same time!
Connect the ground terminal to the closest point on the chassis of the vehicle. Keep this ground wire to less than 39" (100 cm) in length. Use 8 gauge
(or heavier) wire.
Connect the remote terminal to the remote output of the head unit using 16 gauge (or heavier) wire.
Connect a fuse holder within 18" (45 cm) of the car battery, and run 8 gauge empty to the amplifier location. Then connect the fuse from this fuse
holder to the "BATT+" connection on the subwoofer rear panel.
Loading ...
Loading ...
Loading ...