Loading ...
Loading ...
Loading ...
13 14
WASH CYCLE
• The table below shows which programs are bet for each cleaning job and how much
detergent is needed.
Program Cycle
Information
Description
of Cycle
Detergent Time
(min.)
Energy
(Kwh)
Water
(Gallon)
NORMAL To clean
normally
soiled
dishes
Wash
(136)
Rinse
Rinse (158)
Drying
.3 oz 130
min.
0.29 1.3
RAPID Shorter
wash for
lightly
soiled
dishes
Wash (122)
Rinse
Rinse
.3 oz 40 min. 0.27 1.3
BABY
CARE
Suitable
for washing
selttob ybab
(Steam
Added)
Wash(158)
Rinse
Rinse(162)
Drying
.3 oz 120
min.
0.5 1.3
Wash hard
surface fruit
by manually
adding cold
water
Wash No
Detergent
20 min. 0.2 1.3
GLASS For lightly
soiled
delicate
dishware
Wash (122)
Rinse
Rinse (144)
.3 oz 110
min.
0.19 1.3
STARTING A WASH CYCLE:
1. Load the basket( according to guidelines in the "Loading the Dishwasher" section.
2. Load the detergent according the "Wash cycle table”and "Adding Detergent" section.
3. Insert the plug into the socket. The power supply is 120VAC 60HZ
4. Press the power button to turn on the appliance,
5. Connect the inlet hose to the tap, make sure that the water supply is turned on to full
pressure, or add water the tank manually.
6. Select a suitable program according to the “Wash cycle table”
7. When a program is selected, the appropriate light will illuminate.
8. Press the Start/ Pause button and the machine will start.
9. To pause the dishwasher press the Start/Pause button. An alarm will sound every
minute until the button is pressed again to restart the wash cycle.
TO CHANGE A WASH CYCLE:
A w
ash cycle can only be changed if it has been running for a short time prior to
detergent being released and water being drained.
1. Press the Start/Cancel button to pause the washing.
2. Then press and hold the Press Start/Cancel for more than 3 seconds, the machine will
go into stand by mode.
3. Press a new program button to select the desired program
FORGET TO ADD A DISH?
You can only add a dish if the dishwasher has been running for a short time prior to
detergent being released and water being drained.
1. Press the Start/Cancel button Or open the door a little to stop the washing cycle. When
the door is opened the machine will pause.
2. After the spray arms stop working, you can open the door completely.
3. Add forgotten dishes.
4. Close the door.
5. Press the Start/Cancel button, the dishwasher will run .
6. NOTE: It is dangerous to open the door when washing, has commenced because the
hot water may scald you.
WHEN THE CYCLE IS COMPLETE
of the dishwasher. Wait a 15 minutes before unloading the dishwasher to avoid
burning yourself, as the dishes and utensils are still hot.
Switch OFF the Dishwasher
1.
2.
3. NOTE: When unloading the dishwasher it is normal that a small bit of water will remain.
FDW05ASBWHA_Manual_vF.indd 13-14 5/20/19 3:08 PM
FRUIT
Note: Fruit wash program need to fill with water below 86°F manually, to keep the
freshness in shap.
*
*
Loading ...
Loading ...
Loading ...