Loading ...
Loading ...
Loading ...
16 C6647M (10/21)
In-Ceiling or Wall Mount w/ Embedded Junction Box (IBP3BBAP-EI)
PARTS LIST SUPPLIED WITH THE MOUNT
Figure 5. Installation with Embedded Junction Box
INSTALLATION GUIDE
1. Attach the IBP3BBAP-EI backbox (#1) to the desired surface:
a. Using the Mounting template, mark the desired position of the backbox.
b. Cut a round hole (recommended diameter of 26.9 mm).
c. Incoming cables should be fed through the back bo
x from the back or side depending on your installation.
d. Push the backbox into the hole, making sure the securing tabs are in the inward position so as not to catch on the hole opening.
e. Tighten the screws to secure the back box to the ceiling or wall surface.
2. Attach the Bullet Mounting Base to the cover plate:
a. Feed the All-in-One cable through the center opening of the cover plate.
b. Secure the
Bullet Mounting Base to the cover plate using the 4, M4 x 14 mm Tamper Resistant Screws.
3. Slip the rubber grommet onto the All-in-One cable and then insert the rubber grommet into the center hole of the cover plate (#2).
NOTE: Please identify both sides of the rubber grommet. The angled side must be facing towards the terminals of the cables and cover plate to
prevent water ingress.
4. Secure the rub
ber grommet to the cover plate by attaching the metal plate (supplied) to the cover plate with 3, M3 x 8 mm screws.
5. Refer to the Connecting the Cables section before proceeding.
6. Attached the cover plate (#2) to the back box with the 3, M4 x 10 mm screws (supplied).
7. Proceed the Positioning the Camera section to complete the installation.
Qty Description
1 Sarix Bullet In-Ceiling Mount junction box
1 M
ounting template
4 M4 x 14 mm T20 T20 tamper resistant screws
3 M4 x 10 mm Phillips screws
3 M3 x 8 mm Phillips screws
1 Metal plate
1 Waterproof rubber grommet
Loading ...
Loading ...
Loading ...