Loading ...
Loading ...
Loading ...
35
Assembly
ATTENTION:
• When assembling or inserting the extractor filter and charcoal filter, the appliance must not be
connected to the power supply.
• If mounting accessories are not used, there is a risk of electrocution.
PRECAUTIONS:
• Before installation, check that the wall or wall module has sufficient load capacity to support the
hood.
• When drilling holes in the wall, you should always make sure there are no electrical wires or other
objects that could be damaged.
• Check that ventilation openings are unobstructed.
NOTE: Recommendations for installation
• Ask someone else to help you with the installation.
• Wear protective gloves to avoid injury from sharp edges.
• Determine the position of the hood centered on the hob, respecting the specified
safety distances.
• Mark the holes required for wall mounting using the included drilling template. Check
them with a spirit level.
• Drill the 4 holes of Ø8 mm in the wall and place the dowels.
• Next, tighten the mounting screws (4 x ST4*35) until they protrude about 10 mm from the wall.
• Before hanging the lid, insert the connection piece with the non-return valves.
• Hang the hood and tighten the screws through the hood body. Make sure the mounting is secure
and the position is horizontal.
• Remove the protective plastic from the telescopic duct.
Loading ...
Loading ...
Loading ...