Loading ...
Continued on Next Page
SB-GM-EQNX/10W1v2/BK INSTR_SKU# 011318
s t e P 7
Remove the two nuts holding the top of the enclsoure in
place. Continue by removing the two nuts holding the
bottom of the enclosure in place. Disconnect the sub wiring
and remove the factory sub enclosure. Retain all four nuts
for the installation of the Stealthbox®.
s t e P 6
With the side panel out of the vehicle, the factory sub
enclosure can now be removed.
s t e P 5
Pictured is the weatherstripping removed from the side
panel. Starting here, begin unclipping the side panel and
continue toward the rear of the vehicle, and remove the
panel.
s t e P 4
Open the rear passenger side door. Pull up the
weatherstripping to allow access to the sill panel and side
panel. Remove the sill panel by pulling up on the panel to
release the clips.
Page 2 • JL Audio, Inc 2010
S T E P 9
Attach the two Upper Brackets to the Stealthbox® as shown
using a 1/4” Flat Washer, 1/4” Lock Washer, and 6mm x 25mm
Bolt on each. Hand tighten to allow the brackets to be
adjusted later.
S T E P 1 1
Set the Stealthbox® in place by sliding the bottom of the
enclosure behind the Lower Brackets, and aligning the Upper
Brackets with the upper threaded studs. Hand tighten the
factory nuts on the threaded studs, and mark the location of
the Upper Brackets on the top of the enclosure. Firmly press
the enclosure toward the side of the vehicle, slide the Lower
Brackets into place, and mark the location of the Lower
Brackets on the floor of the vehicle.
Remove the Stealthbox®, align the Upper Brackets with the
marks on the enclosure, and firmly tighten. Align the Lower
Brackets with the marks in the vehicle, and firmly tighten.
S T E P 1 0
Attach the two Lower Brackets to the threaded studs using
the factory nuts, as shown. The smaller, angled bracket goes
on the stud closest to the rear of the vehicle. Hand tighten
to allow the brackets to be adjusted later.
S T E P 8
Pictured without the factory sub enclosure are the threaded
studs that held the bottom of the enclosure in place. It is not
necessary to remove the bracket for the foam floor support.
Loading ...
Loading ...