Loading ...
Loading ...
Loading ...
Alarm
The watch will beep when the alarm time is
reached. You can configure up to four
standard daily alarms, and one daily alarm
with snooze. The hourly time signal causes the
watch to beep every hour on the hour.
●
Snooze causes the alarm to sound up to
seven times, at five-minute intervals.
●
The alarm sound is muted in the cases
described below.
ー
When battery power is low
ー
When watch is at Level 2 power saving
l
Power Saving Function
Configuring Alarm Settings
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Press (D) to scroll through alarms ([1] to
[4], [SNZ]) until the one you want to
configure is displayed.
Alarm number
Alarm time
3. Hold down (A) for at least two seconds.
This causes the hours digits to flash.
Alarm hour
4. Use (B) and (D) to change the hour setting.
●
Holding down (B) or (D) scrolls through
settings at high speed.
●
If you are using 12-hour timekeeping,
[P] indicates p.m.
5. Press (C).
This causes the minutes digits to flash.
Alarm minute
6. Use (B) and (D) to set the minute setting.
7. Press (A) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
●
Testing the alarm
In the Alarm Mode, hold down (D) to sound the
alarm.
●
To stop the alarm
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Snooze causes the alarm to sound up to seven
times, at five-minute intervals. To cancel a
snooze alarm, turn [SNZ] off.
l
Turning Off an Alarm or the Hourly Time
Signal
Note
●
A beeper will sound for 10 seconds to
let you know when the alarm time is
reached.
●
The watch will automatically return to
the Timekeeping Mode from the Alarm
Mode after two or three minutes of non-
operation.
Configuring the Hourly Time
Signal Setting
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Use (D) to display the hourly time signal
screen ([SIG]).
3. Press (A) to toggle the hourly time signal
between enabled and disabled.
●
[SIG] (hourly time signal) is shown on
the display while the hourly time signal
is enabled.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
●
To have an alarm or hourly time signal
sound again, turn it back on.
Note
●
Indicators are displayed while any of
the alarms or the hourly time signal is
turned on.
●
The applicable indicators are not
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Alarm
Snooze
Hourly time signal
Watch Operation Guide 3545
11
Loading ...
Loading ...
Loading ...