Loading ...
Loading ...
Loading ...
5
regulations. Please shut down the device in prohibited area.
Use of the product must be in strict compliance with the local electrical
safety regulations.
Use the power adapter provided by qualified manufacturer. Refer to the
product specification for detailed power requirements.
It is recommended to provide independent power adapter for each
device as adapter overload may cause over-heating or a fire hazard.
Make sure that the power has been disconnected before you wire,
install, or disassemble the device in the authorized way according to the
description in the manual.
To avoid electric shock, DO NOT directly touch exposed contacts and
components once the device is powered up.
DO NOT use damaged power supply devices (e.g., cable, power adapter,
etc.) to avoid electric shock, fire hazard, and explosion.
DO NOT directly cut the power supply to shut down the device. Please
shut down the device normally and then unplug the power cord to avoid
data loss.
The socket-outlet shall be installed near the equipment and shall be
easily accessible.
Make sure the power supply has been disconnected if the power
adapter is idle.
Connect to earth before connecting to the power supply.
DO NOT touch the bare metal contacts of the inlets after the circuit
breaker is turned off. Electricity still exists.
To avoid heat accumulation, good ventilation is required for a proper
operating environment.
Store the device in dry, well-ventilated, corrosive-gas-free, no direct
sunlight, and no heating source environment.
Avoid fire, water, and explosive environment when using the device.
Install the device in such a way that lightning strikes can be avoided.
Provide a surge suppressor at the inlet opening of the equipment under
special conditions such as the mountain top, iron tower, and forest.
Keep the device away from magnetic interference.
Avoid device installation on vibratory surfaces or places. Failure to
comply with this may cause device damage.
Loading ...
Loading ...
Loading ...