Loading ...
Loading ...
Loading ...
Laser Distance Meter
Memory (419D/424D)
29
6. Make sure that the Meter is perpendicular to the wall.
7. Push to trigger the bottom target (3)
measurement.
The result is the partial vertical distance between
target 1 and target 2. The third measurement shows
in the secondary line.
As an option, use the tracking mode on one or more
targets. To use tracking mode:
1. Push and hold
for 2 seconds to start tracking
mode.
2. Move the laser side to side and up and down on the
ideal horizontal target point.
3. Push
to stop the tracking mode.
Memory (419D/424D)
You can recall a previous measurement from memory, for
example, the height of a room. The Meter stores a
maximum of 20 displays.
To recall:
1. Push 1x.
2. Push and to move through the stored
displays.
and the memory ID show on the display.
3. Push for 2 seconds to use the value shown in
the Summary line for further calculations.
To delete:
1. Push
and at the same time.
The Meter deletes all the stored values in memory.
Maintenance
Maintenance and calibration is not necessary for the
Meter. To keep the Meter in good condition:
• Remove dirt with a moist, soft cloth.
• Do not put in water.
• Do not use aggressive detergents or solutions.
Disable the Meter
If damaged, do not use and disable the Meter. To disable,
remove the batteries. See page 6 for more information.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...