Loading ...
Loading ...
Loading ...
63/66/68
Operating the Thermometer
19
HOLD
The unit’s display will remain activated for seven seconds after the
trigger is released, unless the unit is locked on (lock on 66/68
only). HOLD appears in the upper left of the display. During HOLD
or after the unit shuts off, recall stored values by pressing
without pulling the trigger (66/68). Each time
is pressed, the
unit advances through the function cycle. When the trigger is pulled
again, the unit will begin measuring in the last function selected.
Storing Data (66/68)
The thermometers are capable of storing up to 12 data locations.
The infrared temperature, temperature scale (°C or °F), and
emissivity are also stored.
To store data from an infrared reading, pull the trigger. While
holding the trigger, press
until LOG appears in the lower left of
the display. A log location number is shown below LOG. If no
temperature has been recorded in the shown LOG location, 3
dashes will appear in the lower right corner. Aim the unit at the
desired target and press
. A tone confirms that the location
temperature has been recorded. The recorded temperature
appears in the lower right corner of the display. To select another
log location, press
or .
Recalling Data (66/68)
Recall stored data after the unit shuts off by pressing until LOG
appears in the display’s lower left corner. A LOG location is shown
below LOG and the stored temperature for that location will be
shown in the display’s lower right corner. To move to another LOG
location, press
or .
LOG Clear Function
The LOG Clear function allows you to quickly clear all logged data
points. This function can only be used when the unit is in LOG
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...