Loading ...
Loading ...
Loading ...
SOAP
NOTICE
Page 18
USING CHEMICALS
Pressure washing with volatile, ammable, or corrosive liquids could cause pressure
washer damage, re, or explosion resulting in severe injury and/or death. To avoid these
hazards, use only approved soaps and chemicals, do not attempt to pressure wash with
volatile, ammable, or corrosive liquids, and NEVER use bleach.
VOLATILE LIQUIDS
Attach the open end of the soap hose to the barbed tting (A) on the pump - OR -
connect the soap injector (B) to the high-pressure outlet of the washer.
1.
Place the ltered end of the soap hose into a
container of soap.
2.
Insert the black nozzle into the spray wand per the
Nozzle Installation section of this manual. NOTE:
Soaps will not siphon if the black soap nozzle is
not installed on the spray wand.
4.
High-pressure
hose connector
High-Pressure
washer
connector
Soap injector
If the engine is running, make sure the trigger
lock is in the locked position before removing and
installing nozzles.
3.
5.
After using soap, place the ltered end of the soap hose into a container of clean
water and run pressure washer drawing clean water through the hose and pump
until the system is thoroughly rinsed. If soap or other chemicals remain in the pump,
the pump could be damaged. Pump damage from soap or chemical residue is not
covered under warranty.
A
B
Loading ...
Loading ...
Loading ...