Loading ...
Loading ...
Loading ...
Blade Service (continued)
6. If the difference between A and B is greater than 3 mm (1/8 inch), replace the blade.
Note: If you replace the blade and the difference continues to exceed 3 mm (1/8 inch),
the blade spindle could be bent. Contact an Authorized Service Dealer for service.
7. Repeat this procedure each blade.
Removing the Blades
1. Hold the blade end using a rag or thickly padded glove.
2. Remove the blade as shown.
G451425
Sharpening the Blades
G000552s
1. Use a file to sharpen the cutting edge at both
ends of the blade. Ensure to maintain the
original angle
.
Note: Remove the same amount of material
from both cutting edges so that the blade
retains its balance.
G000553s
2. Check the balance of the blade by putting it
on a blade balancer
.
Note: If the blade stays in a horizontal
position, the blade is balanced and can be
used.
If the blade is not balanced, file some metal off the end of the sail area only.
3. Repeat this procedure until the blade is balanced.
3464-625A Page 5–26 Maintenance: Mower-Deck Maintenance
Loading ...
Loading ...
Loading ...