Troy-Bilt 31AH97P7711 MANL:OPERATOR MANUAL:BILING:TB:31X:97X

Loading ...

Figure 3-2

 Looking beneath the handle panel, check that all of the

cables (steering, auger, and drive) are properly routed

and not pinched or kinked. Make certain the springs at

the lower end of the auger and drive cables are securely

hooked into their respective actuator bracket. See Figure



5. Secure the upper handle, support tubes and lower handle

with the two wing nuts, bell washers and carriage bolts

removed earlier. Tighten the two wing nuts already

installed in the upper holes to firmly secure the upper

handle and support tubes. See Figure 3-3.

Figure 3-3

Assembly

IMPORTANT: Two replacement auger shear pins are included

with this manual (or stowed in the plastic handle panel). Refer to

the Maintenance section for more information regarding shear

pin replacement.

NOTE: All references in this manual to the left or right side of the

snow thrower is from the operating position only. Exceptions, if

any, will be specified.

IMPORTANT: This unit is shipped with the engine full of oil.



included with this unit for fuel and oil fill-up details.

NOTE: Specifications are subject to change without notification

or obligation. Images may not reflect your exact model and are

for reference purposes only.

Handle

 Remove any packaging material from the upper handle.

2. Remove the lower wing nut, bell washer and carriage bolt



Figure 3-1

3. Raise the upper handle assembly until it snaps over the

lower handle. See Figure 3-2.

Contents of Carton

     

 

Manual

 Two Replacement Auger Shear Pins  

Assembly & Set-Up

Loading ...

Troy-Bilt 31AH97P7711 Polar Blast 4510 Snow Blower