Loading ...
Loading ...
Loading ...
5
UNDER CABINET INSTALLATION
Before Installation
1. Read any provided document(s).
2. Test the range hood by temporarily connecting it to an outlet and turning ON the fan and lights.
3. If you run into any problems, contact KOBE Range Hoods.
Venting Options and Requirements
4. The range hood has 3 exhaust options: Top 6” Round, Top
3-1/4” x 10” Rectangular, and Rear 3-1/4” x 10”
Rectangular. The range hood is factory set for vertical or
horizontal venting using round or rectangular vent adapter.
5. Decide the location of the venting pipe from the hood to
the outside. A straight, short vent run will allow the hood to
perform more efficiently. Try to avoid elbows, transitions,
and long run as much as possible as this may reduce the
performance of the hood. Make sure that the duct work
leads to the outside.
6. It is recommended to use metal/aluminum duct/pipe with a
uniform size (ex. 6” round pipe from range hood to the
outside).
7. If an elbow is necessary, a minimum of 12” straight run is
necessary before the elbow.
8. For Top 6” Round vent installation: The 6” Round vent is
already attached. (Refer to Figure 1)
9. For Top 3-1/4” x 10” Rectangular vent installation only:
Remove attached 6” Round vent and discard. Keep seven
screws to install the rectangular vent. Align and secure
Top Vent Cover with Rectangular Opening with one screw.
Then align and secure 3-1/4” x 10” Rectangular with two
screws. (Refer to Figure 2)
10. For Rear 3-1/4” x 10” Rectangular vent installation only:
Remove attached 6” Round vent and discard. Keep seven
screws to install the rectangular vent. Align and secure
Top Vent Cover with seven screws to block the top
exhaust (Figure 3). Remove the duct knockout from back
of the hood. Keep the screws and discard the duct
knockout. Then align and secure 3-1/4” x 10” Rectangular
with two screws (Figure 4).
Clearance
11. Clearance is the distance between the cooktop and the
bottom of the range hood. The recommended minimum
clearance for this model is 26” and the maximum clearance
is 30”.
12. It is important to install the hood at the recommended
clearance. Installing too low could result in damage and/or
fire hazard while installing too high may result in reduce
performance and efficiently.
*Note: 6” Round Vent Exhaust is pre-installed
on the range hood.
Figure 1
Figure 2
Figure 3
Loading ...
Loading ...
Loading ...