Loading ...
Loading ...
Loading ...
7
WALL MOUNT INSTALLATION
Before Installation
1. Read any provided document(s).
2. Test the range hood by temporarily connecting it to an outlet and
turning ON the fan and lights.
3. If you run into any problems, contact KOBE Range Hoods.
Venting Options and Requirements
4. The range hood has 3 exhaust options: Top 6” Round, Top 3-1/4”
x 10” Rectangular, and Rear 3-1/4” x 10” Rectangular. The range
hood is factory set for vertical or horizontal venting using round or
rectangular vent adapter.
5. Decide the location of the venting pipe from the hood to the
outside. A straight, short vent run will allow the hood to perform
more efficiently. Try to avoid elbows, transitions, and long run as
much as possible as this may reduce the performance of the
hood. Make sure that the duct work leads to the outside.
6. It is recommended to use metal/aluminum duct/pipe with a
uniform size (ex. 6” round pipe from range hood to the outside.).
7. If an elbow is necessary, a minimum of 12” straight run is
necessary before the elbow.
8. For Top 6” Round vent installation: The 6” Round vent is already
installed. (Refer to Figure 1)
9. For Top 3-1/4” x 10” Rectangular vent installation only: Remove
attached 6” Round vent and discard. Keep seven screws to install
the rectangular vent. Align and secure Top Vent Cover with
Rectangular Opening with one screw. Then align and secure 3-
1/4” x 10” Rectangular with two screws. (Refer to Figure 2)
10. For Rear 3-1/4” x 10” Rectangular vent installation only: Remove
attached 6” Round vent and discard. Keep seven screws to install
the rectangular vent. Align and secure Top Vent Cover with seven
screws to block the top exhaust (Figure 3). Remove the duct
knockout from back of the hood. Keep the screws and discard the
duct knockout. Then align and secure 3-1/4” x 10” Rectangular
with two screws (Figure 4).
Clearance
11. Clearance is the distance between the cooktop and the bottom of
the range hood. The recommended minimum clearance for this
model is 26” and the maximum clearance is 30”.
12. It is important to install the hood at the recommended clearance.
Installing too low could result in damage and/or fire hazard while
installing too high may result in reduced performance and efficiently.
Hood Installation
13. Secure hood-mounting bracket and two duct cover-mounting bracket support on top of the hood
with eight 4*12 screws. Refer to Figure 5.
*Note: 6” Round Vent Exhaust is pre-
installed on the range hood.
Figure 1
Figure 2
Figure 3
Figure 4
Loading ...
Loading ...
Loading ...