Loading ...
Loading ...
Loading ...
Installation Instructions
The appliance must not be located immediately below a socket outlet.
NOTE: Your Panel Heater should be installed with at least 150mm clearance from the
floor and any other surrounding parts including other appliances and side walls.
At least 300mm clearance from ceilings, shelves and soft furnishings.
Note: Do not run the power cord behind the heater.
WALL MOUNTED HEATERS ARE
ONLY TO BE MOUNTED ON HEAT
RESISTANT WALLS THAT COMPLY
WITH CURRENT AS/NZS
SPECIFICATIONS & BUILDING
REGULATIONS
150mm
300mm
150mm
150mm
WALL MOUNTED
1. Make sure the appliance is unplugged and power switches are off.
2. Position the panel appliance within one metre of a wall socket. Do not mount in front of or
below the wall socket. Ensure there is at least 150mm clearance on all sides of the
appliance.
3. Use drill dimension paper to drill top two holes(Φ8) on the wall and put the expansion
screws in the holes as picture (2).
4. The hook racks are pre-assembled on the back of the heater, hang the top two hook racks
on the screws as picture (3). Mark the two bottom hook racks’ position on the wall and take
away the heater, then drill bottom two holes(Φ8) on the wall and put expansion screw’s
plastic cover in the holes as picture (3).
5. Hang the heater on the wall and put the expansion screws in the bottom two holes as
picture (4).
6. Plug appliance into a standard 240 volt AC electrical outlet.
Picture 1
Picture 2 Picture 3
Picture 4
Loading ...
Loading ...
Loading ...