Loading ...
Loading ...
Loading ...
Press the power button to turn the heater on. The current temperature will be displayed on the
screen.
To turn the heater off, press the power button for at least 2 seconds until the heater switches
off.
Temperature Setting
Press the + or – control button to set the temperature. The display will flash and the
temperature will increase or decrease by 1°C after each press. The temperature will be saved in
3 seconds after no further action. The display will show the room temperature after the
temperature has been set.
Temperature can be set from 5 – 35
o
C
Default temperature setting is 22
o
C
If the room temperature is 1°C higher than the set temperature, the unit will stop heating. If the
room temperature is 2°C or more lower than the set temperature, the unit will start heating.
Timer Setting
Press the timer function button to enter into 24 hour ‘countdown’ timer setting. Press the + or –
control button to set the amount of time required. The display will flash and the timer will
increase or decrease by 1 hour after each press. The timer will be saved in 3 seconds after no
further action. The display will show the room temperature after the timer has been set.
Timer can be set from 0 – 24 hours
Once the number of set hours has passed, the unit will turn off.
Open Window Function
The heater has an open window function. Press the open window function button to enter the
setting. Press the + or – button to turn on or turn off the open window function. The display will
show “OF” when the function is off. The display will show “ON” when the function is on.
When this function is activated, if you open a window widely in the space where the heater is
located and the temperature drops by 2°C or more in two minutes, a sensor will detect the
sharp drop in temperature. The heater will switch off automatically and “FO” will flash on the
display. The heater will automatically start heating again after 10 minutes. You can manually
start the heating function before the 10 minutes has passed by pressing the open window
function button. “FO” will disappear from the display and will show the previous operation
mode. The default setting of open window function is off.
Plug the power plug into a power point and switch on the power source. The heater will beep
once and will be stand by mode and the display will show “OF”.
Operating Your Heater
Loading ...
Loading ...
Loading ...