Loading ...
Loading ...
Loading ...
6
Anti-tip Location
C
C
Cabinet
Rear
Floor
A
Cabinet
Opening
Cabinet
Opening
C
C
Dimension A = Cabinet opening minus the refrigerator height + 1-1/4" (3.2 cm)
Ex. - Cabinet opening height - 85”
Minimum refrigerator height (sitting on rollers) - 83 15/16”
A = 85” - 83-15/16” +1-1/4” = 2-5/16”
Anti-tip Bracket
The anti-tip bracket has several holes set up on a grid in order to
better locate a wall stud. At least 4 places must be used. Anti-tip
Bracket must be centered in cutout - side to side.
NOTE: Number and type of fasteners must be suitable in order to
prevent tipping. For example: use wood screws into wall studs or
masonry anchors if attaching to stone, brick or concrete.
If a wall stud can not be found or when installing
the 18” model, use the lower section of the bracket
and mount to the base board
WARNING
Proper placement of anti tip bracket is an important function of the installation
process. The installer shall check and make sure that the unit is getting engaged with
the bracket when they try to tilt the unit from top similar to the unit tipping condition.
If the depth of the cabinet is more than the speci ed dimension of
25" (63.5 cm), anti tip bracket shall be installed with spacer (Shims)
to maintain the bracket location to be 25" (63.5 cm).
Loading ...
Loading ...
Loading ...