Loading ...
Loading ...
Loading ...
7
Energy Saving
For better energy saving we suggest :
• Installing the appliance away from heat sources and not exposed to direct sunlight and in a
well ventilated room.
• Avoid putting hot food into the refrigerator to avoid increasing the internal temperature
and therefore causing continuous functionalizing of the compressor.
• Do not excessively stuff foods so as to ensure proper air circulation.
• Defrost the appliance in case there is ice to facilitate the transfer of cold.
• In case of absence of electrical energy, it is advisable to keep the refrigerator door closed.
• Open or keep the doors of the appliance open as little as possible
• Avoid adjusting the setting to temperatures too cold.
• Remove dust present on the rear of the appliance
Before first use
You must allow the fridge to settle for at least four hours prior to switching the
power on.
It is recommended that you clean the interior of the appliance prior to first use, using a
solution of bicarbonate of soda and warm water and then thoroughly drying the interior.
The fridge may have an odor to it at first use. This will disappear as the appliance cools.
Please note:
The appliance will start 41 °F (5°C) for fridge and -0.5 °F(-18℃) for freezer and work
continuously until it comes down to the correct temperature. If the appliance is switched
off, you should allow five minutes before switching it on again to prevent unnecessary
damage to the compressor. Never store inflammable or explosive items and strong
corrosive acids or alkalis in the appliance. This fridge cools your food by making the inside
back of the cavity cold. It is normal for frost to build up on this surface; it then dissipates
and drains through a small drain at the bottom, where it evaporates harmlessly. The
presence of frosting at the back is not a malfunction of the fridge.
Loading ...
Loading ...
Loading ...