EGO PGX3000D User Manual

Loading ...

PGX

™

COMMERCIAL CHARGING 3-PORT DOCK — PGX3000D/PGX3000D-FC14

MOUNT THE DOCK (FIG. 4)

Wall-mount Holes

1. Make sure the two rubber blocks t into the upper slots of back on the dock.

2. Mark the locations of the ve wall-mount holes at the desired location on a wall.

3. Use ve #8 or #10 screws with the length of at least 2.5” (63 mm) and washers

(not included) to securely mount the dock to the wall.

NOTICE: Mounting surface should be at least 3/4’’ (19 mm) thick to securely support

the dock.

Wall-mount Holes (5)

Rubber Blocks (2)

Mounting onto E-track Rail

(Fig. 5)

EGO E-track mounting kit AEK1000 (sold

separately) is required to mount the dock

onto an E-track rail.

1. Disconnect the dock from the hub

and remove the battery packs.

2. Remove the 2 rubber blocks shown

in Fig. 2.

3. Install the E-track clips (included in the kit) into the recessed areas (vacated by

the rubber blocks) as shown in Fig. 5.

4. Use the assembly tool (included in the kit) to secure each E-track clip to the dock

using M5 bolt and washer sets (included in the kit).

5. Insert two rubber bumpers (included in the kit) into the outer lower slots on the

back of the dock.

Bolt and

washer set (2)

E-track Rail

Rubber

Bumper(2)

E-track Clip(2)

Loading ...

EGO PGX3000D PGX Commercial Charging 3-Port Dock